|
|
Dribond® 100
Heat-Activated Clear Coat™ Overlay |
|
Clear Coat™ Overlay Dry Film and Sealer
| Available in rolls
or sheets |
Crystal clear or
colored |
| Thickness
.002" - .10" |
High gloss &
Low gloss finishes available |
| Application
Temperature is 210°F+ |
Extremely long
shelf life (no limit found) |
| Fuses to almost
any substrate |
Not effected by H2O |
| Polyester
chemistry |
Very good vapor
barrier |
| No VOC's |
Adds stability and
strength |
| Fast - Safe - Easy |
FDA safe |
| This
film can also be used for clear FDA compliant overlay, giving high or low
gloss finish (depending on release sheet used).
Temperature fur fusing / bonding overlay to
surfaces like smooth wood is approximately 190° F. In certain cases you may
wish to heat to 210°F, but generally a lower temperature is better.
Estimated time is 2 - 3 minutes at a
pressure of about 100 psi (this can vary).
Best to hot stack till cool unless your
press has a cooling cycle.
See
Technical Data Sheet |
|
Dry Film home |
Metric Conversions |
Release Sheets |
FAQs
Lenderink Technologies, Inc.
1267 House Road · Belmont, Michigan 49306 USA
Phone (616) 887-8257
· Fax (616) 887-7910 ·
Sales@DryFilmAdhesives.com
Clear Coat Overlay and Sealer |
Heat Activated Adhesive |
Pressure Sensitive Adhesive
Veneer Backing |
Laminating Equipment |
Printable Brochures |
MSDS |
Technical Reference
Comparison Sheets:
Thermoplastic | Thermo
Set | Veneer Backer | Pressure Sensitive
|
Dry Film Home