Coat front or back...                            SAVE time and money...

Low Price: Expensive coating machines are not needed! The Dry Film Adhesive Laminating System will coat up to 40+ feet (lineal) per minute and up to 62" wide!

Short runs: Run as needed - Cut inventories - Stop storing and continually inventorying large quantities of materials.

Save Time: Apply Dry Film Adhesive or Overlay as needed. Quickly supply your own needs... Just-In-Time!

Easy to Use: 2 hour training! 1 or 2 workers per machine.

EPA / OSHA will love you: No mixing... no spray guns... no spray booths... no glue pots to clean up.

Efficient and Compact: Minimal energy - minimal setup - coat or laminate up to 40+ feet (lineal) per minute up to 62" wide.

Equipment starts at approximately $5000 (24" Bench Top).

Step 1 - Load Dry Film Adhesive and Overlay into payout rack and thread material though to rewind shaft.

Load glue onto payout bar.

Step 2 - Start machine, setting "Speed" and "Heat". 

Step 3 - Close compression rolls and roll glue onto top heated roll, starting coating process.

To STOP coating process, push "Retract" button, opening compression rolls.